Specifies which network port Pixelmapper will use to output data. This is defined by the IP address of available network cards.
Only IP Addresses from enabled and connected Network Cards will appear in this list.
|Note: The configuration of IP addresses should be carried out before starting Pixelmapper. A guide to setting IP addresses can be found here.|
Sets the behaviour of receivers where multiple sACN senders are present on the network. This can be used to define what happens in the event a controller stops transmitting. The higher priority station on a network takes control. If a higher priority station stops transmitting, the next highest priority sender will take control after a short delay.
Two senders with the same priority will normally merge their values on each receiver.
|Note: The exact priority behaviour depends on the make and model of receiver.|
Artnet Refresh Rate
How often a new frame of Art-Net is sent over the network. Older Art-Net receivers or very congested networks may benefit from a lower refresh rate.
KiNET Refresh Rate
How often a new frame of KiNET is sent over the network. Older KiNET receivers or very congested networks may benefit from a lower refresh rate.
sACN Refresh Rate
How often a new frame of sACN is sent over the network.