You are here: Home » Support
Knowledgebase: Hints and Tips
Setting up Zookeeper to control a dual output on the Hippotizer
Posted by Nick Charalampidis on 22 January 2009 05:50 PM

Information:
To use two Monitors for Zookeeper you will need to access windows output settings or ATI output settings.

 

Windows Output Settings: 
Right click on the Windows desktop and click Properties. Select the settings tab and within this tab please make sure both monitors are connected by enabling them and click Identify.
Please make sure both monitors are next to each other in the set-up window. If they are not you will need to move one of the monitors closer by dragging them in the interface.

 

ATI Output Settings:
Right Click on the desktop and Select ATI Catalyst Control Centre. Within this tab please make sure both monitors are connected by enabling them and also clicking Identify. 
Both monitors should be next to each other in the set-up window. If they are not you will need to move one of the monitors closer by dragging them in the interface.

 

Once you have both your monitor connected and situated next to each other you can now start the Zookeeper. Right click on the header bar at the top of the Zookeeper application and select Restore. This will allow you to grab the Zookeeper window and move it around. You can also drag the Zookeeper window out to become bigger and fill 2 screens. This is accomplished by hovering over one of the edges of the Zookeeper window a left / right arrow will appear allowing the window to be dragged to the desired size.

 

 

 

Applies to Software version
All 

 

 

 

Applies to hardware version
Stage, HD, Genlock HD

 

 


Login
Password:

Subscribe

 
Knowledgebase